CAD CAM EDM DRO - Yahoo Group Archive

Posts by George Potter

George Potter 1999-05-20 17:11:33 UTC Re: Position Readout Question and Introduction George Potter 1999-05-21 21:55:38 UTC Re: Position Readout Question and Introduction George Potter 1999-06-16 22:56:54 UTC Re: List answer George Potter 1999-06-20 06:41:08 UTC Re: EDM George Potter 1999-07-16 22:57:53 UTC Re: EDM, was Re: Cheap Encoders George Potter 1999-08-15 21:50:32 UTC Re: EMC Running My Controller George Potter 1999-09-14 10:41:57 UTC Re: Low cost Servo Controller George Potter 1999-10-17 21:20:07 UTC Re: A new list ? George Potter 1999-10-18 16:51:04 UTC Re: What do we want? George Potter 1999-10-30 23:25:58 UTC Re: Free Intellicad George Potter 1999-11-07 11:10:47 UTC Re: Re: Spindle motor drive belts MAXNC 10 UPDATE George Potter 1999-12-22 21:17:27 UTC Re: The tape-O-matic... George Potter 1999-12-24 17:44:55 UTC Re: Surface Mounting Components. George Potter 2000-01-13 21:35:50 UTC Re: Driving gantry with two paired stepper motors George Potter 2000-01-15 10:58:03 UTC Re: toothed sprocket set screw George Potter 2000-01-31 22:13:32 UTC Re: Optoisolation for a modem George Potter 2000-02-01 21:43:19 UTC Re: Re: Optoisolation for a modem George Potter 2000-02-16 20:51:02 UTC OpenCNC??? George Potter 2000-05-04 07:31:11 UTC Re: [CAD_CAM_EDM_DRO] CAD VS Drafting Table Re: Names George Potter 2000-05-04 19:14:39 UTC Re: [CAD_CAM_EDM_DRO] Auto Cad Lt George Potter 2000-07-17 18:41:35 UTC Re: [CAD_CAM_EDM_DRO] Re: LARGE DC MOTOR speed control question George Potter 2000-07-30 07:20:25 UTC Re: [CAD_CAM_EDM_DRO] Air Cylinder Press George Potter 2000-08-03 21:35:50 UTC Re: [CAD_CAM_EDM_DRO] Monitor Help/Red Hat George Potter 2000-10-14 07:56:03 UTC Re: FCC Approval George Potter 2000-10-15 16:02:08 UTC Re: FCC Part 15 George Potter 2000-10-16 16:50:40 UTC Re: The old FCC thing George Potter 2002-02-14 21:30:01 UTC Free To A Good Home!!!